Track Shot Blasting Machine SMB100-P7.5-1

产品参数

所属分类
设备名称:Track Shot Blasting Machine SMB100-P7.5-1

浏览次数:83
发布日期:2020-03-24

产品概述 技术参数

Comparison before and after shot blasting

Track Shot Blasting Machine SMB100-P7.5-1Product description

① This model adopts an integrated structure design. The whole machine is integrated into a single machine from the shot blasting room, the hoist, the dust collector, the electric box, etc., with a small area and convenient transportation

② Made of polyurethane track, good toughness, high strength and abrasion resistance, shot blast cleaning for some parts that can collide with each other;

③ It is made of ordinary steel plate + Mn13 steel plate body, and the inner body protection plate is Mn13 steel plate, which is fixed by wear-resistant screws;

④Suitable for shot blasting of small and medium-sized parts.

Comparison of shot blasting process

Track Shot Blasting Machine SMB100-P7.5-1


A. Installation instructions:

During installation, compare the general drawing of the equipment, place the main unit on the prepared foundation, fasten it with bolts, and install the upper part of the hoist to the main unit with bolts.

Install electrical conduit and complete wiring according to electrical drawings such as electrical schematics and interconnection diagrams

Place the spirit level on the bottom surface of the hopper, combine the base of the feeder, add the gasket and level it, and then tighten the bolt connecting the anchor bolt to the cleaning room

B. Commissioning instructions:

Adjust the position of the orientation sleeve opening

Adjust the shot supply valve and the amount of shot blasting according to the current display

Adjust the position of the counterweight to make the shot form a uniform waterfall

Adjust the upper pulley of the hoist to prevent misalignment of the belt

Adjust the sorter pipeline valve to achieve the separation effect

C. Equipment training content description:

Institutional performance and routine maintenance of equipment

Inspection method of wearing parts: replacement standard, cycle and method

Equipment operating procedures, technical requirements and methods for safe operation debugging




Track Shot Blasting Machine SMB100-P7.5-1

Serial number

Model parameter configuration

Standard type
1Equipment application

Rust removal on the surface of small castings / forgings, aluminum die castings, hardware and other parts


2Dimensions L * W * H(mm)
3End plate diameter(mm)

400

4End plate spacing(mm)

650

5

Dissolve(m³)

0.1
6

Maximum load(kg)

100
7Production cycle (per batch / min) 5-10
8Dust emission (mg / m³)≤20
9noise(db)≤65
10Total equipment power(kw)10
11Compressed air loss(m/min)0.1
Serial number

Model parameter configuration

Standard type
1Shot blasting room full manganese steel body
2

Spiral pusher fault alarm system

3

Elevator shot recycling fault alarm system

4

DC-1 Cartridge Dust Collector

5

SMDC-25 wet dust collector

6

Q7.5 shot blasting machine

 ●
7

P7.5 full machine plus shot blasting machine

8

Dust cyclone separation system

9

Automatic lifting door

10

Automatic feeding mechanism

11

Automatic cutting mechanism

12

Semi-automatic flow control system

13

Automatic flow control system

14Shot blasting machine frequency control
15

Electrical cabinet air conditioner

16

Storage bin alarm system

17

Soundproof room

18Vibrating screen steel shot sorting system
19

Tooling customization

20

Random Accessories