Classification:Shot Blasting Equipment
Device name:Track Shot Blasting Machine SMB600-P11-2
Browse times:443
Release date:2020-03-24
Comparison before and after shot blasting
product description
① The equipment is made of high-strength abrasion-resistant tracks, with good toughness and high strength, and shot blast cleaning of some parts that can collide with each other;
② The shot blasting room is made of ordinary steel plate + Mn13 steel plate body, and the inner body protection plate is Mn13 steel plate, which is fixed by wear-resistant screws;
③ The door body of the shot blasting room is controlled by a single cylinder, and the upper and lower opening and closing operations make the door surface contact + EPDM rubber sealing strip to prevent the shot body from splashing out of the room body. The automatic feeding system adopts a hydraulic control system. The system is equipped with a power-off, gas-holding and safety control system to improve the safety of the entire machine operation;
④The unloading system uses a motor to automatically unload the material. A workpiece storage frame is placed at the exit of the vibration. The height of the storage frame is 600mm (can be designed according to customer requirements). The workpiece is automatically transported into the storage frame. The whole machine adopts a full-automatic loading and unloading system, which can realize production operations connected with automated production lines, reduce various costs and improve production efficiency;
⑤ The equipment is equipped with a SWDC-80 wet dust collector system. This system has a high efficiency dust removal effect, the dust emission reaches 20mg / m 3, and it is safe, environmentally friendly, fireproof and explosion-proof, without any maintenance costs in the later stage.
Comparison of shot blasting process
A. Installation instructions:
During installation, compare the general drawing of the equipment, place the main unit on the prepared foundation, fasten it with bolts, and install the upper part of the hoist to the main unit with bolts.
Install electrical conduit and complete wiring according to electrical drawings such as electrical schematics and interconnection diagrams
Place the spirit level on the bottom surface of the hopper, combine the base of the feeder, add the gasket and level it, and then tighten the bolt connecting the anchor bolt to the cleaning room
B. Commissioning instructions:
Adjust the position of the orientation sleeve opening
Adjust the shot supply valve and the amount of shot blasting according to the current display
Adjust the position of the counterweight to make the shot form a uniform waterfall
Adjust the upper pulley of the hoist to prevent misalignment of the belt
Adjust the sorter pipeline valve to achieve the separation effect
C. Equipment training content description:
Institutional performance and routine maintenance of equipment
Inspection method of wearing parts: replacement standard, cycle and method
Equipment operating procedures, technical requirements and methods for safe operation debugging